LANCOM VP
-
100
쮿
Chapter 3: Making telephone calls with the LANCOM VP
-
100
25
EN
쮿
Swap call
If you have two simultaneous connections you can use the Flash/Call hold
key to switch between them. You will be connected to one of the other
callers; the other caller is placed on hold.
쮿
Call forwarding, Transfer
왏
Unattended call forwarding
To forward a call to the third person, press the Call hold key, dial the
required telephone number and then press Hold key. As soon as the
dialed subscriber accepts the call, the two callers are connected. If the
dialed subscriber is not available, you can retreive the call by pressing
the Hold button again.
왏
Attended call forwarding
If you are connected with two callers, one being on hold, you can
connect them with one another. Similarly, a caller you have placed on
hold can be connected with another telephone number of your
choice. The existing call is placed on hold with the Flash/Call hold key.
Now dial a number to make a second call. After reaching the second
caller and, for instance, informing them of the call, press the Transfer
key. To two callers are now connected and you no longer have any
active calls or calls on hold.
Support of the transfer function depends upon the SIP proxy that the
LANCOM VP-100 is registered with.
쮿
Conference calls
To initiate a telephone conference with three callers, the first connection
has to be established and the caller placed in hold with the Flash/Call hold
key. You then dial the number of the second participant and press the hash
key
or
to dial. Once the dialed person picks up the call, press
the Conference key and all three participants will be connected. By
pressing the Conference key again the conference call is stopped and you
can swap between the two lines .
쮿
Do not disturb
The 'Do not Disturb' function activated with the DND key places the
telephone on standby. In this state the telephone receives no calls and
does not ring. You can make calls yourself, however.
Summary of Contents for VP-100
Page 1: ...LANCOM VP 100...
