LANCOM OAP
-
54
-
1 Wireless – LANCOM OAC
-
54
-
1 Wireless
Chapter 3: Basic configuration
35
EN
햴
Enter the wireless parameters. Select a network name (SSID) and a radio
channel. Turn on if necessary the function for ’closed network’. Confirm
your choice with
Next
.
햵
In the following 'Security settings' window, specify a password for confi-
guration access. Note that the password is case-sensitive and ensure that
it is sufficiently long (at least 6 characters).
You may specify whether the device may only be configured from the local
network or whether remote configuration via the WAN (i.e. a remote net-
work) is also permissible.
Please note that enabling this will also permit remote configuration
via the Internet. You should always make sure that the configuration
access is suitably protected, e.g. with a password.
햶
In the next window, select your DSL provider from the list that is displayed.
Confirm your choice with
Apply
.
If you select 'My provider is not listed here,' you must enter the transfer
protocol used by your DSL provider manually in the next window. Confirm
your choice with
Apply
.
햷
Connect charge protection can limit the cost of DSL connections to a pre-
determined amount if desired. Confirm your choice with
Apply
.
햸
The basic setup wizard reports that all the necessary information has been
provided. You can end the wizard with
Go on
.
Entering the password in the web browser
When you are prompted for a user name and
password by your web browser when accessing
the device in the future, enter your personal
values to the corresponding fields. Please note
that the password is case-sensitive.
If you are using the common configuration
account, enter the corresponding password only.
Leave the user name field blank.
Entering the configuration password
