LANCOM L- 54ag Wireless – LANCOM L- 54g Wireless – LANCOM IAP- 54 Wireless
Chapter 2: Installation
14
EN
Flickering
means, that the LED is switched on and off in irregular inter-
vals.
Power
This LED indicates that the device is operational. After the device has been
switched on, it will flash green for the duration of the self-test. After the self-
test, either an error is output by a flashing red light code or the device starts
and the LED remains lit green.
The power LED flashes red/green in alternation until a configuration
password has been specified. Without a configuration password, the
configuration data of the LANCOM is insecure. Under normal circum-
stances, you would assign a configuration password during the basic
configuration (instructions in the following chapter).
off
Device off
green
blinking
Self-test when powering up
green
Device ready for use
red/green
blinking alternately
Device insecure: configuration password not assigned
red
blinking
Time or connect-charge reached
Flashing Power LED but no connection?
There is no need to worry, if the Power LED of a LANCOM 54 Wireless
base station blinks red and you can no longer connect to the WAN.
This indicates that a preset time or connect-charge limit has been
reached. There are three methods available for unlocking:
Reset time limit.
Increase the limit that has been reached.
Completely deactivate the lock that has been triggered (set limit to '0').
If a time limit has been reached, you will be notified in LANmonitor. To reset the connect
charge protection, select
Reset Charge and Time Limits
in the context menu (right mouse
click). You can configure the connect charge settings in LANconfig under
Management
Costs
(you will only be able to access this configuration if ’Complete configuration display’
is selected under
View
Options…
).
You will find connect charge protection reset in WEBconfig and all parameters under
Expert
Configuration
Setup
Charge- module
.
Signal for a time limit
or connect charge limit
that has been reached
Power
LANCOM
Systems
