Lancom DSL/I-1611, Manual

Page: 27 / 66

|
Basic configuration
27
|
LANCOM Office
|
EN
b If you would like to configure the TCP/IP settings manually, assign an
available address from a suitable address range to the
LANCOM Office .
Confirm your choice with Next .
c Specify whether or not the router should act as a DHCP server. Make your
selection and confirm with
Next .
d In the following window, specify the password for configuration access.
In addition, you may specify whether the device may only be configured
from the local network, or whether remote configuration via the WAN
and/or via ISDN is also permissible. Confirm your choice with
Next .
Please note that enabling this will also permit remote configuration via
the Internet. You should always make sure that the configuration access
is protected with a password.
e Now configure the ISDN interface. Confirm your choice with Next .
f If you would like to configure the ISDN settings for your LANCOM Office ,
enter the subscriber number (as MSN, i.e. without area code) on which
the router will accept calls. In addition, you can enter a trunk code for
dialing into ISDN. Finally, you should specify whether or not the tariff
information is to be transmitted at your ISDN connection. Confirm your
choice with
Next .
g Complete the configuration with Finish .
4.1.2 4.1.2 Basic configuration with WEBconfig
As you know, it is possible to configurate with WEBconfig your LANCOM
Office with any web browser. So you are not dependent on the operating sys-
tem Windows as with LANconfig .
The only precondition: You must know how to address the unconfigured
router in the LAN. An unconfigured
LANCOM always reacts to a certain IP
address, and in some network configurations even to a name.
Does my LANCOM Office react to a name?
If you do not yet have a DHCP or DNS server on your LAN, the router reacts
to any name (like 'LANCOM' or 'Router') that you specify in the URL address
field of a web browser.
If you don't know whether IP addresses have been used in your network up
until now, display the IP address of your own PC (see the following section).