LANCOM 3850 UMTS
Chapter 2: Installation
21
EN
Top panel
Two additional LEDs on the top panel provide a convenient overview of the
most important status information, especially when the device is mounted
vertically.
���
Power
This LED provides information on the device's operating state. After being
switched on, it blinks green during the self-test. The LED then shines con-
stantly to indicate operational readiness, unless an error is detected as indi-
cated by a code blinked in red.
쐇
Online
쐃
Power
Off
Device switched off
Green
Blinking
Self-test after power-up
Green
On (perma-
nently)
Device operational
Red/green
Blinking alter-
nately
Device insecure: Configuration password not set
Orange/green
In the housing
cover; blinking
alternately
with the online
LED
At least one WLAN module is in managed mode and
has not found a WLAN Controller yet. The correspon-
ding WLAN module(s) is/are switched off until a WLAN
Controller is found to supply a configuration, or until
being switched manually into another operating mode.
Orange /red
In the housing
cover; blinking
alternately
with the online
LED
At least one WLAN module is in managed mode and
has found a WLAN Controller. However, the WLAN
Controller cannot assign a configuration because the
firmware and/or the device's loader version is not com-
patible with the WLAN Controller.
Red
Blinking
Charge limit for online connections reached
