LANCOM 7100 VPN – LANCOM 9100 VPN
Chapter 2: Installation
16
EN
The power LED blinks alternately in red/green until a configuration
password has been set. Without a configuration password, the con-
figuration data in the LANCOM is unprotected. Normally you would
set a configuration password during the basic configuration (instruc-
tions in the following chapter). Information about setting a configu-
ration password at a later time is available in the section 'The Security
Wizard'.
쐇
Fan
The Fan LED displays the fan's status:
To prevent damage to the hardware, this LED is complemented by an acoustic
signal. If the fan is blocked or the CPU temperature exceeds 60°, a pulsed
acoustic signal is emitted.
The power LED is blinking and no connection can be
made?
If the power LED blinks red and no WAN connections can be
established, there is no cause for concern. This merely means
that a pre-set charge or time limit has been reached.
There are three ways to remove the lock:
Reset the toll protection.
Increase the limit.
Deactivate the lock completely (set limit to '0').
LANmonitor shows you when a charge or time limit has been reached. To reset the toll protec-
tion, activate the context menu (right-mouse click)
Reset charge and time limits
. The charge
settings are defined in LANconfig under
Management
Costs
(these settings are only avail-
able if the 'Complete configuration display' is activated under
Tools
Options
).
With WEBconfig, charge protection and all parameters are to be found under
LCOS menu tree
Setup
Charges
Reset budgets
.
Power
P
ower
Signal that a
charge or time
limit has been
reached
Green
On (permanently)
CPU temperature OK
Orange
On (permanently)
CPU temperature > 55°
Red
blinking
Hardware failure of the fan or CPU temperature > 60°;
additional acoustic signal
