Lancair ES-P, Pilot Operating Handbook

Page: 90 / 122

diodes to direct current for charging the batteries. The alternators use
remotely mounted LR3C and LS1A B & C Specialties voltage
regulators mounted inside the cockpit on the fuselage wall in the pilot
footwell.
Excessively high voltage regulation will cause overcharging of the
batteries and shorten battery life. Low settings will result in a low
battery and probably poor starting, especially in colder weather. The
alternator voltage can be adjusted at the regulators.
CARE AND CLEANING
This carbon fiber airplane requires no special care and cleaning. Prior
to washing, cover the wheels, pitot and static ports and plug cabin air
intake ports. Care should be used to avoid removal of grease and oil
from lubricated areas.
The windshield should be cleaned with generous amounts of water and
a soft cloth. Prepared cleaners should be used with caution unless
expressly made for acrylic material. Oil and grease can be removed
with small amounts of kerosene if necessary, followed by soap and
water.
Never use gasoline, benzene, alcohol, acetone, carbon tetrachloride,
anti-ice fluids, lacquer thinners or glass cleaners.
They will either
soften the material or cause it to craze. Rubbing of the surface with a
dry cloth should be avoided as its causes static electricity build-up,
which subsequently attracts dirt and dust particles.
WARNING
The windows are a bonded-in part of this aircraft
and are extremely difficult and time consuming to
replace. Use the utmost care when servicing or
otherwise handling them.
Upholstery materials and carpets can be cleaned in the normal manner.
Rubber seals can be lubricated with Oakite 6, Armorall or equivalent
materials. A vacuum is the primary means of cleaning the interior of
loose dust and dirt. Blot up any liquid spills as soon as possible with
cleansing tissues or clean rags. Hold the material securely against the
spill for a few seconds, allowing it to absorb the liquid. Repeat until all
liquid is removed. Scrape off any gum materials. Test a spot remover
on a test piece of material or an out of sight location if there is any
question as to the compatibility of the cleaner and the upholstery or the
carpet materials. If acceptable, clean areas of spots as necessary.
Detergent foams can be used to clean carpets if used per the