26
6
Operation
6.7
Set Values
Fig. 6-7 Set values in the data setting window
You can access the data setting window by activating this button in the main menu.
1
The burner can be switched on.
2
If the burner is in operation, a firing-rate value can be preselected here and the firing-
rate value can be overwritten externally or by the load controller.
3
Sends a reset signal to the connected device.
4
Sends a reset signal to the CO/O
2
control.
(Only available from data module software version V2.)
5
Sends a deactivation command to the connected device.
(Only available from data module software version V2.)
6
Close window
