Lamtec F300K Series, Manual

Page: 95 / 126

94
11 Network
As soon as you connect an FB30 user interface to the F300K, the integrated user interface is
deactivated. When you disconnect the FB30 from the F300K, the internal user interface is re-
activated.
USB-Modul-Adapter – F300K Remote Software
You can use the F300K Remote Software to:
• Parameterise the F300K.
• Save and re-write a data set.
• Display information and use the "what would happen if?" function (= analysis by simulating
different parameter settings).
• Record flame data and data of FSB modules and display it for analysis.
• Save and print the parameterisation as a commissioning log.
When you connect the F300K Remote Software to the F300K, this deactivates both the UI in-
tegrated user interface and the FB30 external user interface. When you disconnect the F300K
Remote Software from the F300K, either the integrated user interface or the external user in-
terface is reactivated.
Fieldbus Gateway
The Fieldbus Gateway can make the data of the F300K available to other bus systems.
The following external bus systems are possible:
• MODBUS RTU slave, MODBUS TCP slave
• Other bus systems depending on the available hardware
FSB modules
FSB modules can:
• Provide four analogue and digital modules.
• Send data to the F300K Remote Software for recording and analysis.
Further information
You will find further information on networking in a separate description.
(Project Planning). Document DLT7670