10_
LAMONA
Appliances
Installation
Clearances and dimensions requirements
270mm
50mm in
150mm min between hob and rear wall (158mm min to cut out aperture)
400mm min
490mm
Minimum distance
between carcasses must
be equal to overall width
of all hobs
*
Minimum height to extractor
as recommend in extractor
instruction manual
*
55mm min between hob and rear wall
(>60mm to cut out aperture)
270mm
No shelf or overhang of combustible material should be closer than 650mm directly above the hob.
There must be a minimum clearance of 50mm between the rear edge of the hob and the rear wall. This
clearance must be maintained up to 650mm above the worktop (unless otherwise stated in your extractor
manual).
Apply the self adhesive seal around the perimeter of the worktop cut-out. For best results, the seal should
be adhered along each side in turn, as close to the edge as possible, and trimmed at each corner, taking
care to ensure a neat join.
