12_
LAMONA
Appliances
Installation
Installation above an oven
If the appliance is installed with an oven
underneath, please leave at least 15mm of
ventilation, unless otherwise stated in your oven
installation guidelines.
Installing the product
- Self adhesive seal
Turn the hob underside down, place it on a
fl at protected surface.
Apply the self adhesive seal to the
underside edges of the hob glass. For best
results, the seal should be adhered along
each side in turn, as close to the edge as
possible, and trimmed at each corner, taking
care to ensure a neat join.
DO NOT
e
h
t
r
e
d
n
u
t
n
a
l
a
e
s
e
n
o
c
il
i
s
t
if
glass hob instead of the self-adhesive seal.
Worktop
15mm
Oven
Hob
5mm
Before installation
The product should only be installed by suitably
qualifi ed persons.
The product must be installed in accordance
with all local regulations.
Prior to installation, visually check the product
for any damage/defects. Do not install if any issues
are found.
Damaged products may cause risks to your own
safety.
The appliance is intended for installation in
Installation
Howdens kitchen cabinets.
•
Surfaces, synthetic laminates and adhesives
used must be heat resistant.
•
Kitchen cabinets must be set level and fi xed.
•
If there is a drawer beneath the oven, a shelf
must be installed between oven and drawer.
•
The following installation drawings are
representational and may not match exactly
with your appliance.
If the installation is n
Gently insert hob into cut out, allowing clips to
hold the hob in place.
ot above an oven and the
underside of the hob is accessible, a wooden shield
is required to be installed at least 15mm below the
underside of the hob unit.
15 min.
Summary of Contents for LAM1704
