31
7.4 Menu 04 “CHOOSE LANGUAGE”
Allows you to select the dialogue language among those available.
7.5 Menu 05 “STAND-BY MODE”
This menu allows you to activate or deactivate "STAND-BY".
Stand-by mode indicates a condition in which the stove shuts off but where it automatically re-ignites as soon
as the room temperature and the water temperature fall below the set value and the flue gas temperature
drops below its threshold (stove is cold). Default setting is "OFF".
Once the stand-by Menu is set to a value between 1'-120', if the water temperature or room temperature
exceed a certain amount, set values (2°C for room temperature and 4° for water temperature), an alternating
message "MODULATE / OK STD BY" appears on the screen. At this point, after a pre-set time (default 10
minutes), if temperatures do not return under the set values, the stove shuts off and goes into stand-by mode.
During shutdown, the display shows the message "WAIT COOLING." This display message remains until re-
lighting conditions are verified.
7.6 Menu 06 “BUZZER MODE”
When "off," acoustic signal disabled in the event of an alarm. When "on," sets off a buzzer when an alarm is
activated.
7.7 Menu 07 “INITIAL LOAD”
When the display shows the message "OFF," allows you to preload pellets for a time equal to 90 min. Start
by pressing button "1" and stop if desired by pressing button "4." Once preloading is completed, remove the
loaded pellets from the brazier.
7.8 Menu 08 “STOVE STATUS”
The stove status menu shows the current state of the stove, showing some sensor values and other
variables inside the stove. Four pages displayed in succession are available. This menu is for qualified
service personnel use.
7.9 Menu 09 “TECHNICAL CALIBRATIONS”
This menu is protected by an access key and is intended for qualified service personnel.
