LAMINOX FSH HP KING 12DC32, User Manual

Page: 7 / 47

- 7-
4 INSTALLATION
4.1 General points for installation engineer
4.1-1
Preparation before installation
Make sure the site is large enough to hold all the equipment and has enough
operation space.
Measure the hoisting path to ensure that the path to the installation site is
unobstructed and prevent the equipment from reaching the site during
Installation.
Confirm that the power meter capacity and the wire capacity are sufficient and
the phase (three-phase, two-phase) meets the requirements.
Plan the layout of the equipment according to the customer’s site. And strive to
have the shortest and the most straight water pipe and enough space for
operation and maintenance.
For the heat pump with side outlet wind, consider the local wind direction and
choose a reasonable installation direction to avoid the wind direction being opposite.
Current regulations require the heating installation to be inspected before it is commissioned.
The inspection must be carried out by a suitably qualified person and should be documented.
If the heat pump is replaced, the installation must be inspected again. In the event of
installation with unvented (closed) heating systems, make sure the pipeline has an exhaust
valve (an automatic air exhaust valve is included in the heat pump). If necessary, installation
engineer may add additional air exhaust valves to the pipeline
.
4.1-2 Sitting the heat pump
The heat pump should be firmly fixed to a base, preferably a concrete base
，
It
is the most suitable that the right end is 5-10mm higher than the left end. As
shown below: