LAMAX eRacer SC50, User Manual

Page: 9 / 100

6 7
EN
CS
CZ
CZ
CZ
CZ
CZ
CZ
–
After charging the scooter, disconnect the charger from the power socket and the power cord from the
scooter.
–
Do not leave the scooter connected to the charger longer than necessary to fully charge.
!ATTENTION!
–
Only use the charger supplied with the battery.
–
Never cover the charger.
–
If the charger or any part of it is damaged, it must be replaced with a new one. Never use such a char-
ger. There is a risk of electric shock. Contact your dealer, the manufacturer of the equipment or an
authorised service centre for replacement.
–
NEVER use the scooter while it is connected to a charger.
–
Charge the battery in a dry place at room temperature between 5 °C and 40 °C.
–
The battery and/or charger might get warm whilst charging and does not indicate a fault.
–
Do not recharge for longer than necessary.
–
The scooter must always be charged under constant supervision!
Charging procedure
1 2
3
1. Switch off the scooter before charging.
2. Remove the rubber cap of the charging socket on the right side (1).
3. Connect the charger (2).
4. Insert the charger mains plug into the socket.
5. If the charger light is red, the battery is charging.
6. When charging is complete, the indicator light on the charger will turn green.
7. After charging, insert the rubber protective cover of the charging socket back in (3).
8. APPLICATION
This scooter can be connected via Bluetooth to a smartphone app, which allows you to view more information
about the scooter, adjust various settings in more detail, lock the scooter, control it remotely, see the current
battery status and temperature, track the history of the last ride, and other detailed riding data.
Note: connecting the application to the scooter is an additional function that is not necessary for the operation of the
scooter. We do not guarantee its full functionality with all types of phones for the lifetime of the device.
a) Scan the QR code or go to
https://www.lamax-electronics.com/eRacer-SC50/app
b) Install the app on your smart device.
c) Turn on the scooter.
d) Turn on Bluetooth and GPS location on your smart device.
e) Launch the app and search for „LAMAX eRacer SC50“ and connect to the scooter.
ATTENTION:
In order for the app to function normally on your smart device, it is necessary to grant all the appropriate
permissions during installation.