4
5
EN
CS
CZ
CZ
CZ
CZ
CZ
CZ
DESCRIPTION OF ICONS
Pedestrian mode
(pedestrian riding mode, where the maximum speed of the scooter is 6 km/h, sui-
table for pushing up hills, etc.)
Locking the scooter
(the scooter can be locked via the smartphone app, if anyone subsequently
moves it or switches it on, a loud alarm will sound and the wheels will be locked, making it impossible
to ride it away. Unlocking is again only possible via the app)
Cruise control
(automatic maintenance of selected speed without the need to hold the throttle,
which can be set in the smartphone app. Any acceleration or braking will immediately turn off this
function and engage manual speed control)
High temperature
(high-temperature warning – if you get this warning on the display, the scooter
will automatically start to slow down for safety reasons. It is recommended to stop and wait for the
temperature to return to normal or ride more slowly)
Bluetooth
(an icon on the display indicates that you are connected to the scooter via the app)
Headlight
(icon on the display indicates the headlights are on)
Driving modes
(the „E, D, S“ icons tell you which driving mode is currently active. If none of these
three is lit, then you are in pedestrian mode and the display shows a red ladybird icon, see point 1)
Voltage
(display shows current battery voltage -» triple press the power button while the display is on
to change between voltage, current and speed)
Current
(display shows current battery current -» triple press the power button while the display is on
to change between voltage, current and speed)
Speed
(display shows the current speed of the scooter -» triple press the power button while the
display is on to change between voltage, current and speed)
Distance travelled
(the display shows the total distance travelled by the scooter)
Turn signal
(signalling a change of direction– an icon indicates that the left or right turn signal is on)
6. ASSEMBLING AND FOLDING THE SCOOTER
Assembly
1. Carefully remove the scooter from the box, place it on the ground and fold out the kickstand. Adjust the
handlebar post to the upright position.
2. Attach the handlebars by tilting the folding mechanism towards the handlebar post. Connect the cable from
the handlebars and the cable in the handlebar post so that the arrows on the cables are facing each other and
then slide the handlebars into the post. Secure both parts with the six screws provided and the Allen wrench.
3. After assembling the scooter, test the functionality of the brakes and the strength of the joint at the handlebar
post. Press the main power button and test that everything works properly.
4. Then switch off the scooter and fully charge it.