LAMAX eFalcon ATV50M, User Manual

Page: 18 / 150

12 13
EN
CS
CS
CZ
CZ
CZ
CZ
CZ
WARNING!
The product creates an electromagnetic field of very weak intensity. However, this field may interfere with
some pacemakers. To reduce the risk of serious or fatal injury, persons with pacemakers should consult their
physician and pacemaker manufacturer regarding vehicle use.
UNPACKING
–
After unpacking the product from the box, carefully inspect all parts.
–
Before disposing of the packaging materials, always carefully check whether any parts of the quad bike
are left inside the packaging.
–
Keep packaging components (plastic bags, clips, etc.) out of reach of children.
–
If the product is damaged during unpacking or if the delivery is incomplete, contact your dealer imme-
diately.
BOX CONTENTS
–
Quad bike body, handlebars and their mounts (2 upper, 2 lower, 4 screws), front and rear protective frame,
front plastic bumper, front right and left wheels, charger, 2 fuses, instruction manual, tools.
–
Standard accessories are subject to change without notice.
–
This product requires assembly. The vehicle must be properly assembled before use.
ASSEMBLY
–
We recommend assembling the quad bike with an experienced mechanic. In the case of assembling the
quad bike yourself, we recommend two people assemble it.
–
Assembly takes approximately 30-40 minutes.
–
The initial battery charge can take up to 12 hours.
–
Do not shorten this charging time!
–
Inflate all 4 wheels to the appropriate pressure (69 kPa / 10 PSI).
–
Unpack the quad bike from the box.
–
Remove the bolts that attach the quad bike to the iron frame.
–
Remove all loose parts from the packaging (quad body, front wheels, front plastic bumper, front and rear
metal frame, manual, charger, and a set of screws and tools). See images 1 and 2.
REAR WHEELS
–
Put the wheel on the drawbar… picture (3).
–
Tighten the outer wheel bolt securely.
–
Fit the outer rim to the wheel frame.
FRONT WHEELS
–
Fit the front wheels and front brake disc picture… (4, 5 and 6).
–
Fit the wheel onto the steering knuckle.
–
Then fit the brake shoe onto the brake disc and tighten all screws.
–
Tighten the outer wheel bolt securely.
–
Repeat for both the left and right front wheel.
DIRECTORY
–
Attach the handlebars using the black washers and four screws... picture (7 and 8).
–
Tighten the screws carefully.
–
Assemble the LCD display… picture (9).
FRONT BUMPER
–
Attach the front bumper… picture (10).
REAR METAL FRAME
–
Attach the rear metal frame to the rear of the quad bike picture… (11).