Laird WB45NBT, Quick Start Manual

Page: 5 / 13

Laird WB45NBT
WB45NBT Quick Start Guide
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wi-fi
5
Laird Technologies
Americas:
+1-800-492-2320
Europe:
+44-1628-858-940
Hong Kong:
+852 2923 0610
Q
UICK
S
TART
G
UIDE
– WB45NBT
Inventory of Equipment
Qty. Item
1
WB45NBT device
1
BB45NBT Breakout board
2
U.FL ultra-micro coax cable male to male SMA plus 2 nuts and washers
2
Dual band 2.5G and 5G antenna with reverse female SMA connector
4
Standoffs and nuts
3
Small Philips head screws
1
USB A to micro USB 1m cable
1
1m CAT 5 e cable
1
USB-to-RS232 DB9/DB25 adapter
1
Micro USB to USB A type convertor
1
Power supply 12V 1A negative center with wall (US/European) adapter cable
Additional Required Tools
Qty.
Item
1 Small Philips head jeweler’s screw driver
Hardware Installation and Configuration
To assemble the WB45NBT evaluation kit, follow these steps:
1. Attach the standoffs to the underside of the BB45NBT board.
2. Connect the 2 U.FL coax cables to the 2 U.FL connecters on the underside of the WB45NBT board.
Figure 1 shows the location of the Wi-Fi and Bluetooth antennas.
Note: To prevent damage, you must connect the U.FL ultra-micro coax cables to the connectors on
the WB45NBT prior to fitting the WB45NBT to the BB45NBT evaluation board.