laguna Smart Shop M2, Owner'S Manual

Page: 59 / 75

Smart Shop "M" Maker 2 59
Resetting Tool Location & TTO Location
Resetting Tool Location:
Home the machine.
This will reset the controller's machine coordinates, relative to the position of the home switches and flags.
Verify the controller is in machine coordinates (workpiece 0).
If not, press MENU+ZRN/0 to change to machine coordinates.
Put an EMPTY tool cone into the spindle using the manual tool release button.
Using the handheld controller's jog control, carefully guide the cone into the tool rack.
Remove Dust Hood to visually see Tool Cone.
**Recommendation-1/8 Inch clearance from the back of the Tool Clip to prevent over travel.**
Resetting Tool Locations (Cont'd)
Record the X, Y, and Z position.
Verify that these are in machine coordinates.
Carefully jog the tool out of the tool rack.
Navigate to the ATC stored locations, by following the below steps.
MENU --> Menu Function User Interface --> REF/OK.