laguna PX|22 Sheartec:II, Owner'S Manual

Page: 9 / 52

9 PX|22 Sheartec:II Planer \ Electrical Safety
Electrical Safety
WARNING!
·
RUNNING ON A DIFFERENT VOLTAGE THAN STATED BELOW WILL DAMAGE THE MACHINE. NEVER RUN THE
MACHINE IN WET OR DAMP CONDITIONS.
·
ELECTROCUTION, FIRE, SHOCK, OR EQUIPMENT DAMAGE MAY OCCUR IF MACHINE IS NOT PROPERLY GROUNDED
AND CONNECTED TO POWER SUPPLY.
Power Supply
A separate electrical circuit should be used for each machine. This circuit should not be less than the wiring
listed below and should be protected with an appropriate circuit breaker based on the total running and
start-up amperage's (listed below). If an extension cord is used, use only 3-wire extension cords which
have 3-prong grounding type plugs and matching receptacle which will accept the machine’s plug.
MPLANPX2275-0130
VOLTAGE 220V
PHASE 1PH
HERTZ 60Hz
FULL LOAD AMPERAGE 32 AMP
Below are RECOMMENDATIONS to be used for this machine based on the above
information. Variables that may affect this are:
·
Actual voltage supplied to the machine
·
Electrical code that must be met in your local province.
An electrician will verify that all the demands are met to properly wire the machine. If you have
absolutely any doubt when wiring this machine - please consult with a qualified electrician.
PLUG/RECEPTACLE Not Included
WIRING (Gauge) See Jacket Printing
CIRCUIT BREAKER 40 AMP
MPLANPX2210-0130
VOLTAGE 220V
PHASE 3PH
HERTZ 60Hz
FULL LOAD AMPERAGE 28 AMP
Below are RECOMMENDATIONS to be used for this machine based on the above
information. Variables that may affect this are:
·
Actual voltage supplied to the machine
·
Electrical code that must be met in your local province.
An electrician will verify that all the demands are met to properly wire the machine. If you have
absolutely any doubt when wiring this machine - please consult with a qualified electrician.