5
Uncrating the Machine
Uncrate the machine and inspect the unit for
signs of shipping damage. If damage is found,
contact your dealer immediately. Unbolt the
machine from the pallet. Retain all packaging
materials in case it becomes necessary to ship
the machine to another site.
Machine Preparation and Setup
The jointer must be positioned on a smooth,
level surface. The area must be well lit and
have plenty of room to maneuver with large
pieces of wood.
Level the jointer front to back and side to
side using a level placed on the table. Use
shims under the corners, if necessary, but
make sure the jointer is the jointer is stable
before being placed into service.
Clean all rust protected surfaces with a
commercial solvent. Do not use acetone,
gasoline, lacquer thinner or any type of
flammable solvent, or a cleaner that may
damage paint. Cover cleaned surfaces with
WD-40 or a 20W machine oil.
Warning :The equipment used to lift this
machine must have a rated capacity at, or
above the weight of the jointer. Failure to
comply may cause serious injury!
Dust Collection
The 6” dust collection port (A, Fig. 1) is located
below the outfeed table. Typically flex hose is
used to run from this point to a central trunk
line.
Note: Do not operate the jointer without dust
collection.
Fig. 1
Fig. 1
A
