laguna 506601, Owner'S Manual

Page: 8 / 48

8 JX|6 & JX|8 Quadtec:I Jointers \ Electrical Safety
Electrical Safety
WARNING!
·
RUNNING ON A DIFFERENT VOLTAGE THAN STATED BELOW WILL DAMAGE THE MACHINE. NEVER RUN THE
MACHINE IN WET OR DAMP CONDITIONS.
·
ELECTROCUTION, FIRE, SHOCK, OR EQUIPMENT DAMAGE MAY OCCUR IF MACHINE IS NOT PROPERLY GROUNDED
AND CONNECTED TO POWER SUPPLY.
Motor Specifications
The typical main motors are either a 1.5 HP (JX6) or a 1.75 HP (JX8) and are wired for 110 Volt, Single-
Phase, 60 HZ, AC current. Confirm your motor electrical configuration before connecting power! Before
connecting the machine to the power source, make sure the starter and switches are in the "OFF" position.
Power Cord and “plug” are NOT included. These must be installed by a qualified technician/electrician to
meet all applicable codes.
NOTICE! A 110 Volt to 220 Volt conversion kit is available for either jointer. Kit part #510220. See “220
Volt Conversion” for kit instructions.
Power Supply
A separate electrical circuit should be used for each machine. This circuit should not be less than the wiring
listed below and should be protected with an appropriate circuit breaker based on the total running and
start-up amperage's (listed below). If an extension cord is used, use only 3-wire extension cords which
have 3-prong grounding type plugs and matching receptacle which will accept the machine’s plug.
506601
VOLTAGE 110V
PHASE 1PH
HERTZ 60Hz
FULL LOAD AMPERAGE 13Amp
Below are RECOMMENDATIONS to be used for this machine based on the above
information. Variables that may affect this are:
·
Actual voltage supplied to the machine
·
Electrical code that must be met in your local province.
An electrician will verify that all the demands are met to properly wire the machine. If you have
absolutely any doubt when wiring this machine - please consult with a qualified electrician.
PLUG/RECEPTACLE Not Included
WIRING (Gauge) See Jacket Printing
CIRCUIT BREAKER 20Amp