laguna 37 x 2, Owner'S Manual

Page: 48 / 82

Double Drum Sander 37 x 2 48
Servicing the Supermax
The basic adjustment procedures for your machine are covered under Setting Up Your SUPERMAX Sander , page
13. Review that section first. If following the general instructions does not solve a specific problem or result in
smooth operation, also check Troubleshooting Your SUPERMAX, page 53. Below are suggested procedures to
follow when more thorough readjustment or replacement is necessary.
ADJUSTING HEIGHT CONTROLS:
Height Adjustment Problems- may be the result of not loosening the set screws in the table support castings before
attempting operation. (This is covered on page XX of this manual, and on the separate unpacking sheet which was
shipped with your machine.) If the set screws were not loosened as instructed, do so now before proceeding further.
Also make sure all moving parts of the height adjusting mechanism are well lubricated, including the miter gears,
column tubes, and threaded height adjusting screws. When troubleshooting the height adjustment mechanism, first
check the conveyor table for level
(See Page 57) , then test the height adjustment mechanism (See Figure 19).
If it does not operate easily, further adjustments may be necessary, as outlined below. Following these steps
should result in smooth operation.