laguna 37 x 2, Owner'S Manual

Page: 32 / 82

Double Drum Sander 37 x 2 32
Machine Operation
Before using your SUPERMAX Drum Sander , review the previous pages in this manual on initial set-up and
adjustment. In this section, you will learn how to operate the machine. Note that connecting the machine to an
adequate dust collection system is necessary before operating the unit.
BASIC OPERATING PROCEDURES
After you have selected and installed abrasive strips, and connected the machine to a Dust Collection System ,
you are ready to begin to use the SUPERMAX . The basic operating procedure for all the SUPERMAX models is as
follows:
1.) Set Depth of Cut.
2.) Start Drum(s).
3.) Start Conveyor and select Feed Rate.
4.) Start Dust Collector System.
5.) Feed stock through unit.
To feed stock through the
SUPERMAX , rest and hold the board to be sanded on the conveyor table, allowing the
conveyor belt to carry the board into the Drum(s). Once the stock is halfway through, reposition yourself to the
outfeed side of the machine to receive and control the board as it exits the unit.