Double Drum Sander 37 x 2
16
Unboxing
UNPACKING YOUR SUPERMAX:
If any damage has occurred because of shipment, notify the transportation company as soon as possible and ask
them to make an immediate inspection. Ask for a damage or loss report.
Important:
To avoid problems and potential damage to the machine, please read the unpacking instructions below
before proceeding to set up the machine in your shop.
1.)
Unbolt the machine legs from the shipping pallet. Install the rubber-based leveling feet or casters on legs
(Figure 2-See Below).
The feet and mounting hardware are in the STOP bag packed with your machine.
2.)
Loosen the hex nut and set screws on the table support castings
(Figure 3-See Below)
.
The set screws on the table support castings have been tightened at the factory to eliminate free play between the
table support casting and the column tube during shipment. There are two table support castings on
the
SUPERMAX
, one each for the right and left column tubes.
Important:
These set screws are tightened for shipping, must be loosened, and readjusted before operating either
the height adjustment mechanism or the conveyor drive.
To properly adjust for operation, loosen each set screw by first loosening its hex nut with an open-end wrench and
then the set screw with an Allen wrench. Then re-tighten each set screw with your fingers not touching the column
tube.
Hold each set screw in position with an Allen wrench and retighten the hex nut. Failure to follow these procedures
may result in misalignment of the drum(s) and/or the conveyor table.
Caution:
On
the SUPERMAX MODELS: Do Not Loosen the Set Screws on the Upper Drum Support
Summary of Contents for 37 x 2
