30
Troubleshooting Guide: Machine
P
ROBLEM
P
OSSIBLE
C
AUSE
S
OLUTION
Brush height adjustment
works improperly.
1.
Improper adjustment of
height control.
Readjust height control
Knocking sound
while running.
1.
Bearing worn.
Replace bearing
Sniping of wood
(gouging near end
of board).
1.
2.
Inadequate support
of stock.
Conveyor drive or driven
Use roller stands to support stock.
Readjust rollers
rollers higher than conveyor bed.
Burning of wood.
or melting of finish
1.
2.
Feed rate too slow.
Excessive depth of cut
Increase feed rate.
Reduce depth of cut,
decrease brush RPM.
Gouging of wood.
1.
Conveyor belt is
too loose.
Adjust belt tension.
2.
Excessive depth of cut.
Reduce depth of cut,
decrease brush RPM.
3.
Wood slipping on conveyor
due to lack of contact.
Use alternate feeding
procedure
Summary of Contents for SuperMax 19-38 Combo
