Laguna Tools PFLUX1, Manual

Page: 27 / 53

1.5HP Mobile Dust Cyclone Manual
26
33. Lift the foot pedal bar. Align the
Octagon drum window to the center
point of the drum lid and push the
drum in. Lower the foot pedal bar to
seal the drum tight for normal
machine operation.
34. Make sure when aligning the
drum that both the left and right-
side lift plates are over the topping
on the foot pedal bar assembly
before lifting the foot peddle bar up.
When not aligned, the drum will not
be fully sealed and will interfere with
the air flow.
35. Using the white plastic pin, insert
the sharp point into the top end of
the proximity sensor that is on top
of the drum lid. You will find a small
hole to on top where you can turn
clockwise or counterclockwise.
※
Clockwise: Lowers dust waste level
in drum (Less full drum)
※
Counterclockwise: Increases dust
waste level in drum (Fuller drum)
36. A qualified electrician must open
the junction box on the Autoclean
motor and remove the strain relief at
the bottom. Take the second motor
cord leading from the top upright
support with the control panel and
insert into the strain relief, connect
the wires according to the
appropriate wiring diagram. Close
and secure the junction box after
you have completed the wiring.
Drum is aligned and locked
Drum not aligned