Laguna Tools DAKE FG-75, Instruction Manual, Page: 33 / 35

961003 REV012021
TROUBLE SHOOTING
PROBLEM / FAULT PROBABLE CAUSE SUGGESTED REMEDY
The motor is not working
properly.
1.Faulty motor, power
cable or
plug. Blown
f
1. Have the motor checked by expert
personnel.
The motor starts
slowly or does not reach
operating speed
1. Low power supply
voltage.
2. Damaged windings
1. Have the motor checked by expert
personnel.
DANGER - WARNING NEVER
ATTEMPT TO REPAIR THE
MOTOR YOURSELF: IT COULD BE
DANGEROUS.
Check the fuses and replace them if
necessary.
The motor is making too
much noise
1. Faulty motor.
Damaged
i di
1. Have the machine motor checked by
expert personnel.
The motor does not reach
full power
1. Mains system
circuits overloaded by
lights, utilities or other
t
1. Avoid using utilities or other motors on
the same circuit to which the machine is
connected.
The motor tends to
overheat
1. Motor overload.
1. Avoid overloading the motor during cutting
operations.
ELECTRICAL DIAGRAM