300Mbps Inwall
Wireless Repeater
Quick Installation Guide
300Mbps Inwall
Wireless Repeater
Quick Installation Guide
Hardware and Operation Mode
LED and Interface
Power
WLAN
Ethernet
System
Gateway Mode
Access Point Mode
Repeater Mode
AP Mode
AP Mode
AP MODE
Repeater MODE
Router/Switch
Operation Mode
Gateway
Router/Switch
Installation Steps
Hardware Connection
Setting the Computer
Log in the Web Management
Setting the AP
Test the Wireless Network
Install the AP to the Wall
Note:
1. Before Install the AP on the wall, you would
better complete the software setting.
2. Before the setting of the AP, you would better
complete the design of Topology of network
and IP address the devices.
Hareware Conection
Setting the Repeater through Wireless
Setting the AP using Wireless
Plug the Wireless Repeater to the Outlet, and using wireless to connect the repeater
(SSID
：
CQ300, Key:66666666), and then log the 192.168.0.1 to setting the Repeater
using the IE Browser.
and then log the 192.168.0.1 to setting the AP using the IE Browser.
Plug the Wireless Repeater to the Outlet, and using wires connect to the repeater
Hardware Connection
Inwall Repeater
Inwall Repeater
Setting the Repeater through Wires with RJ45 Cable
Setting the AP using Wires
As belows shows.
Setting the Computer
Setting the AP through Wireless
same network segment as AP,
subnet mask 255.255.255.0
the default Passwords is"66666666"
CQ300
ZHH
segment as the AP subnet mask 255.255.255.0 As belows shows.
Setting the AP through Wires with RJ45 Cable
1
2
3
WAN/LAN Ethernet Port
Micro USB Port for Power
WPS Button
Power Plug
