laerdal VitalsBridge 100, Directions For Use Manual

Page: 5 / 45

VitalsBridge Directions for Use
4
rev. A.5
Warnings and Caution
The VitalsBridge is intended solely for use during patient simulation. It is not a medical device.
Warning : Never connect the VitalsBridge to a patient.
Warning : Never connect the VitalsBridge to a vital signs monitor that is connected to or in use by a patient.
Warning : The VitalsBridge is not waterproof. Protect the VitalsBridge in damp conditions and keep away from
liquids.
Warning : The VitalsBridge contains a lithium ion battery, which if damaged, could cause risk of fire or explosion.
Follow all cautions and warnings outlined with your patient simulator’s Directions for Use.
Compressed Gases and Regulators (model VB300 only)
The VitalsBridge is supplied with a portable gas regulator that uses cartridges of highly pressurized CO
2
. Take care when
handling these cartridges as they pose a potential risk of injury if used improperly. Cartridges should be stored and
operated at temperatures below 120
o
F (49
o
C) and punctures should be prevented. They should not be heated. Do not
inhale the gas. Adequate training and expertise are required to work with compressed gases.
Warning : Do not use compressed oxygen (fire hazard) or any other flammable substance with or near the
VitalsBridge.
Warning : compressed CO
2
cartridges may become extremely cold when discharging. Protect eyes and hands
when installing and handling cartridges.
Warning : Mishandled compressed CO
2
cartridges may become projectiles.
Caution : Compressed CO
2
cartridges may not be transported by air.
Defibrillation Hazards:
During defibrillation the defibrillator and VitalsBridge may present a shock hazard. All standard safety precautions must
be taken when using a defibrillator with a patient simulator and VitalsBridge.
Warning : Models VB200 and VB300: Defibrillation on the ECG connectors of the VitalsBridge will damage the
internal electronics and may cause personal injury.
Warning : Never connect any cables from the VitalsBridge to the designated defibrillator connectors on your
patient simulator.