LABORIE Solar Blue, Service & Installation Manual

Page: 60 / 198

© 2008
– 2020 by MMS B.V.
59
4.4 Hardware Test
4.4.1 Introduction
The Solar Blue module can be tested in the hardware test program Bluetooth.
Choose
Utilities > Hardware test Bluetooth to start the hardware test
program.
Click on the Solar Blue module button to show the following window.
Figure 4.19 Hardware test Solar Blue module
In case no Bluetooth connection is used, choose
Utilities > Hardware test
Solar (USB) to perform the hardware test. Make sure that the Solar Blue
module is connected to the computer with a USB cable.
Click on the module button to display the information and perform a test.
In the next paragraphs, you will find instructions to test the pump, the pressure
channels and EMG channel, the remote-control unit and to show hardware
status information.