LABORIE Solar Blue, Service & Installation Manual

Page: 29 / 198

28 © 2008
– 2020 by MMS B.V.
Chapter 2
2.8 Pressure Transducer Holder
When pressure measurement is performed with water catheters, a transducer
holder can be used. Different sizes of clamps are available to mount the
transducer holder to the Solar pole (Ø38mm) or to the pressure transducer
pole (see the Solar Blue Assembly instructions laptop integrated set-up 0075-
MAN-099). If necessary, you can change the clamp.
Figure 2.6 Transducer holder pole for water transducers
Put the labels P1..P4 on the transducer holder. With DT-XX pressure
transducers you need interface cables to connect the transducers to the Solar
Blue module. Memscap (formerly Sensonor) transducers can be connected
directly to the Solar Blue module.