Item No. 701157
CopyRight © 2016
1
Introduction
With every CoolSafe Touch, a dedicated software package is delivered without charge. The
CoolSafe Control and Datalogger software facilitates:
Full control of the CoolSafe freeze dryer from an external computer via a USB connection
Complete real-time monitoring and logging of temperature and pressure data from the freeze
drying process running
Viewing and converting data from previous runs.
This manual covers instruction on installing the software and connecting to the CoolSafe freeze
dryer, controlling and running the CoolSafe freeze dryer and logging and handling of the data from
the freeze drying process.
2
Installation and setup of the software
The CoolSafe Control and Datalogger software is delivered on the SD card placed in the SD card
reader located in the back panel of the CoolSafe cabinet.
Remove the SD card and load it into the computer you wish to install the software package on.
On the SD card a single self-extracting installation file is located. By running this file, the CoolSafe
Control and Datalogger software and the needed USB drivers for communication between the
computer and the CoolSafe unit. This software will run on windows based computers running 32 bit
or 64 bit Windows 7 or newer operating systems.
The installation can be run directly from the SD card or from any other media connected to the
computer.
2.1
Loading the SD card
When loading the SD card, Windows will need some time to install the drivers for handling this. This
takes a few moments and will be performed automatically.
Open the SD card and double click the installation file on the SD card.
