Labconco Protector Airo, User Manual

Page: 28 / 112

28
Prudence: Le gaz naturel devrait être seulement utilisé dans l'accessoire de service qui
a été pré soudé avec des tuyaux de cuivre. Le contenu soufré du gaz pourrait causer la
détérioration des lignes d’alimentation en cuivre standard.
Step 4
When the filtered hood has been set in place, wired, and plumbed, it should be sealed
at the work surface to prevent spilled materials from collecting under the walls of the
filtered hood. Materials such as silicone sealants are recommended to seal the hood
structure.
Filter Installation
This section will detail how to install and check the filtration for the hood, including
detailed figures and pictures (all figures will be shown for M3 or 5FT filtered hood). If
using the HEPA filter option, reference
Section 8: Maintaining your filtered hood for
HEPA filter installation and replacement . This section describes how to:

Confirm order and check supplies.

Locate the power supply, command module and anemometer

Unpacking pre-filters, filters and fan boxes

Place pre-filters and stack on primary filters

Stack fan boxes on primary filters

Place secondary filters on fan box

Label all filters and fan boxes

Add protective caps to secondary filters
Step 1
Collect the following tools required to install the equipment:

6ft ladder

Tape and a marker

2 people required
Step 2
To confirm your order, make sure you have the correct number of fans for the filtered
hood size:

M1 (1 column filtration) 3ft Protector Airo

M2 (2 column filtration) 4ft Protector Echo/Airo

M3 (3 column filtration) 5ft Protector Echo

M4 (4 column filtration) 6ft Protector Echo

M5 (5 column filtration) 8ft Protector Echo
Step 3
Each Protector Hood will have the following Neutrodine filters based on their size per
each filtered hood installed.

M1 (1 column filtration) 2 total Neutrodine filters