19
Communication Cable
The freeze dryer power cord should be unplugged before connecting the
communication cable. Connect one end of the communication cable to the port on the
back panel of the tray dryer labeled “OUTPUT TO FREEZE DRYER”. Connect the other
end of the cable to the port on the freeze dryer labeled “DRYING ACCESSORY”. Plug
the freeze dryer power cord back into a suitable power receptacle.
Electrical Connection
Plug the power cord into the receptacle on the back of the tray dryer and plug the other
end into a suitable power receptacle. Plug the power cord into the receptacle on the
back of the freeze dryer and plug the other end into a suitable power outlet. It will take
approximately 90 seconds for the operating system to fully load. Make sure that the
outlets you intend to use meets the voltage and amperage requirements listed on the
serial tags of the tray dryer and freeze dryer.
Do not attempt to plug the power cord from the tray dryer into the freeze dryer.
Ground Strap
The tray dryer comes with a ground stray attached to the back panel. Remove one of
the screws from the back panel of the Extraction Freeze Dryer and attach the other end
of the ground strap.
Power Cord
Ground Strap
Attach Ground Strap to one of the
screws on the Freeze Dryer back panel
Communication Cable
