7. Front Panel Interface
PLM+ SERIES Operation Manual rev
3.0.1
35
7.8. Dynamic Buttons, Controls and LEDs
Figure 7.3: LCD with Dynamic Buttons, Controls and LEDs
7.8.1. Communication LED
A
This bright white LED signifies selection in the Lake Controller, or Controller communication providing visual
confirmation of:
1. Network communication between the Lake Controller and the Lake Processor (Flashing LED).
2. Selection of the Lake Processor in the Lake Controller software (Steady LED).
NOTE: The Communication LED can be dimmed via the front panel by selecting Frame menu, and
then Front > Dimming. Dimming affects all LEDs as well as the backlight of the display.
7.8.2. Frame Faults and Warnings LED
B
All four LEDs on the left flash/off red to indicate a Frame fault and flash yellow/mute state to indicate a Frame
warning. Additional clarification of the current fault or warning is displayed in the bar of the LCD. All mute, fault and
warning states displayed on the front panel are summarized in section 9.1.
Additional faults and warnings are reported in the Event Log of the Lake Controller only. All faults and warnings
recorded in the Event Log are listed in section 9.1 along with scenarios that may have arisen to cause them.
B
A
C
D
