S1 Vivaldi II Owner’s Manual
Page 14
Note that the method below only works if the master temperature is set to either
91ºC or 97ºC. If the temperature is set to 91ºC you can only use the instructions
below to lower the temperature by 1ºC, 2ºC, or 3ºC. If the temperature is set to
97ºC you can only use the instructions below to raise the temperature by 1ºC, 2ºC,
or 3ºC. Consequently you must use the instructions provided in section 4.10.1 to
set the master temperature to 91ºC or 97ºC BEFORE using the instructions below.
If this is not done, the instructions below for entering the Extreme Temperature
Set mode will work as described, but once in that mode attempting to a raise or
lower the temperature has no effect.
Instructions for programming this mode AFTER setting the master temperature to 91ºC
or 97ºC are:
Start with the machine in Standby mode (
ON/STBY
light flashing).
Press and hold the
Two Cup
button for ~3 seconds until lights 94
º
C (17) and
95
º
C(18) come on indicating that the Extreme Temperature Function setting
mode is active.
If you start with the master temperature set to 97
º
C
,
each time that the
Hot
Water
button is pressed, lights 96ºC
(
19), 97ºC
(
20), and Econ (21) will switch on
in succession. Each light indicates a 1ºC increase. All three lights on = 100ºC.
If you start with the master temperature set to 91
º
C
,
each time that the
One Cup
button is pressed, lights 93ºC
(
16), 92ºC
(
15), and 91ºC (14) will switch on in
succession. Each light indicates a 1ºC decrease. All three lights on = 88ºC.
Press the
Two Cup
button again to exit Extreme Temperature set mode and
return back to Standby mode
Note:
When you change the temperature of the 91ºC and/or 97ºC buttons
according to the above instructions, the change only remains in effect until
the temperature is changed. For example, if you change the 91ºC selection
by 3ºC to yield 88 ºC, then later change the temperature to 93C, the next
time you select 91ºC, you will get 91ºC, not 88 ºC. If you wish to obtain
88ºC again you will need to follow the above instructions to reprogram in
the 3 ºC decrease.
4.11 Programmable Preinfusion
Note: only machines purchased or upgraded after 7/1/08 have this feature.
With the machine on (
ON/STBY
(22) lit and not blinking), press and hold the
ON/OFF
button(27) for three seconds until the
ON/STBY
(22) and the current preset temperature
lamps are both blinking. Then press the
BOILER
button (13) for 3 seconds. The
temperature plus
ECON
lamps now display the current time delay between when the
