User instructions - please keep for future reference
Hanging Halogen Electric Heater
69509
V1.0
Produced in PRC for La Hacienda Ltd
Hangar 27, Site C, Aston Down Airfield, Nr Stroud, Glos, GL6 8HR, UK
www.lahacienda.co.uk
Technical information
IMPORTANT! – Carefully remove any packaging before use, but retain the safety instructions.
These instructions form part of the product.
Please take note of all of the safety warnings listed in these instructions.
Please read these instructions in their entirety and retain them for future reference.
These instructions should be stored with the product.
Failure to adhere to these instructions could result in property damage, personal injury or death.
Remote control requires 2 x AAA batteries
(Not Included)
Power Supply: 220 - 240V ~ 50Hz
Wattage: 1000W/2000W
Element Type: Halogen
Life of Lamp: Approximate 5000 hours
Ingress Protection Rating: IP24
Insulation Class: I
Net Weight: 3.5Kg
Dimensions: H 27cm x W 43cm x D 43cm
All measurements are approximate
IMPORTANT! KEEP FOR FUTURE REFERENCE.
Thank you for choosing our outdoor Electric Heater. This manual will provide you with information
necessary for the proper assembly, care and maintenance of your new product. Please take a
few moments to thoroughly read the instructions and familiarise yourself with all the operational
aspects of your new heater.
When using this electric unit, please follow the safety precautions detailed below. This should
reduce the risk of fire, electric shock and injury to persons.
WARNING – CAUTION!
READ ALL INSTRUCTIONS BEFORE ATTEMPTING TO OPERATE THIS UNIT. KEEP THE
ASSEMBLY INSTRUCTIONS FOR FUTURE REFERENCE. KEEP THE ORIGINAL
PACKAGING FOR USE WHEN STORING THE HEATER DURING EXTENDED PERIODS OF
NON-USE.
• Read ALL instructions before using this unit.
• DO NOT leave this unit unattended when in use.
• This heater will get hot when in use. DO NOT touch hot surfaces.
• CAUTION! Some parts of this product can become very hot and cause burns.
Particular attention has to be given when children and vulnerable people are present.
• DO NOT move the unit when in use. Wait until the heater is completely cool before moving
and check that it has been unplugged from the power supply.
• Position the unit at least 1m away from highly combustible materials such as furniture, trees,
leaves, dry grass and bushes.
• The heater MUST be a minimum of 1.8m away from the ground.
• The heater MUST NOT face with the heating element pointing upwards towards a ceiling.
The heater element MUST be facing the area it is to heat.
• WARNING! In order to avoid overheating DO NOT cover the heater. It is not for drying
clothes.
• Keep children and pets at a safe distance from the unit.
• Children of less than 3 years should be kept away unless continuously supervised.
• This appliance can be used by children from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without supervision.
• Ensure any person operating the heater has the capability to do so without risking injury to
themselves or others.
• Children aged from 3 years and less than 8 years shall only switch on/off the appliance
provided that it has been placed or installed in its intended normal operating position and they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved.
• DO NOT operate the heater if ANY signs of damage or malfunction manifest themselves.
• DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. The
unit DOES NOT contain any user serviceable parts. ONLY a qualified electrician should
perform servicing or repairs. Attempting to repair the unit yourself will void your warranty.
• If the power cable is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
• DO NOT handle the element with bare hands. If it is inadvertently touched, remove finger
marks with a soft cloth and methylated spirits or alcohol, otherwise the marks will burn into
the element causing premature heater failure.
• DO NOT replace or attempt to replace the element in this product.
• DO NOT use this heater in the immediate surroundings of a bath, shower, swimming pool or
hot tub.
• This product must NOT be left outdoors exposed to the elements for long periods of time.
• DO NOT touch the plug with wet or damp hands.
• DO NOT run the power cable under carpeting. DO NOT cover the power cable with rugs,
runners, or similar coverings. Arrange the power cable away from foot traffic and where it will
not be tripped over.
• DO NOT wind the power cable around the unit.
• This product is NOT suitable for indoor use.
• DO NOT insert or allow foreign objects to enter any ventilation or opening on the heater, as
this may result in electric shock, fire, or damage to the heater.
• To prevent a possible fire, DO NOT block the air vents.
• A heater has hot and arcing or sparking parts inside. DO NOT use in areas where petrol,
paint, explosive and/or flammable liquids are used or stored. Keep unit away from heated
surfaces and open flames.
• Where possible, avoid the use of an extension cable as this may overheat and cause a fire.
However, if you have to use an extension cable, ensure it is suitable for the purpose, has
been tested for outdoor use and preferably has an RCD device fitted or attached.
• ALWAYS ensure the heater is plugged into a suitable socket, one that is tested for outdoor
use.
• To disconnect heater, turn controls to OFF, then remove plug from socket. DO NOT unplug by
pulling on the power cable.
• ALWAYS unplug the unit and ensure the unit is completely cold before moving, cleaning or
storing.
• The use of attachments on the heater is NOT recommended.
• DO NOT use this heater with a programmer, timer, separate remote control system or any
other device that switches the heater on automatically, since a fire risk exists if the heater is
covered or positioned incorrectly.
• WARNING! This heater is not equipped with a device to control the room temperature. DO
NOT use this heater in small rooms when occupied by persons not capable of leaving a room
on their own, unless constant supervision is provided.
• ALWAYS use on a dry, suitably strong, stable, flat and level surface.
OPERATING THE UNIT:
• To operate, ensure the unit is plugged in to the correct power supply
• Set the red switch on the side of the heater to the “I” position
• This unit is fitted with soft touch control technology. In order to turn the heater ON to its
lowest setting (1000W), lightly press your finger on to the blue power light.
• By pressing the power light again, this will set the heater to its highest setting (2000W)
• By pressing the power light a third time, this will set the heater to standby mode, but will turn
on the LED light
• By pressing the power light a fourth time, this will turn the heater ON to its highest setting
(2000W), in addition to having the LED light ON
• By pressing the power light a fifth time, this will set the heater and LED light in to
standby mode
• To completely turn OFF the unit, set the red switch to the ‘O’ position
•
This heater is supplied with a remote control which requires
2 x AAA batteries (Not included).
To use the heater by remote control, ensure the red switch is set to the “I” position. The
remote control has 3 buttons – please refer to Figure A in diagram B. Button X controls the
LED light: pressing it once will turn the LED light on and pressing it again will put the LED
light in to standby mode. Button Y controls the top element of the heater: pressing it once will
turn the top element ON (1000W) and pressing it again will turn the top element in to standby
mode. Button Z controls the bottom element of the heater: pressing once will turn the bottom
element ON (1000W) and pressing it again will turn the bottom element in to standby mode.
It is possible to have both elements turned on at the same time, in order to achieve the
maximum heat setting (2000W)
MAINTENANCE:
• Before performing ANY maintenance, unplug the unit and let it cool completely.
• To keep the heater clean, the outer casing may be cleaned with a soft, damp cloth. You may
use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth.
• DO NOT use alcohol, petrol, abrasive powders, furniture polish, or rough brushes to clean
the heater. This may cause damage or deterioration to the surface of the heater.
• DO NOT immerse the heater in water to clean.
• Wait until the unit is completely dry before use.
STORAGE:
• Ensure the unit is completely cold before storing in a cool, dry location.
• To prevent dust and dirt build-up, use the original packaging to repack the unit.
• CHOKING HAZARD: Store out of the reach of children and pets. Contains small parts.
Note
