RADIO CONTROLLED CLOCK
WITH PROJECTOR
USER’S INSTRUCTIONS
GETTING STARTED
1. If using the DC Adaptor to power
the clock, plug the adaptor into
the left side of the clock. If using
battery, install 2 AA size
batteries into the battery
compartment, pay attention to
the polarity.
2. When the clock is power on, all
the segments of the LCD will be
shown briefly before entering the
radio controlled time reception
mode.
3. The RC clock will automatically
start scanning for the radio
controlled time reception mode.
Note:
1. If there is no display on the LCD
after inserting the battery, press
RESET key by using a metal pin.
Due to atmospheric disturbances,
the clock may not receive the
signal immediately, try to reset
the clock again during night time.
2. If using battery and DC Adaptor
at the same time, the unit will
automatically select the Adaptor
Power for both clock and
projector.
FUNCTION KEYS
SNOOZE/LIGHT key:
-
Turn the projector and EL on.
Stop the current alarm when the
bell is ringing.
MODE key:
-
Switch between normal time
mode and alarm time mode.
SET key:
-
In normal time mode, toggle
between ºC/ºF temperature
format.
-
In setting mode, step the setting
items.
ADJUST key:
-
Toggle between Date/Month and
Year display.
-
In alarm time mode, switch
ALARM/SNOOZE function on or
off.
-
In setting mode, adjust the value
of the flashing digit.
RECEIVE key:
-
Press it to receive the signal for
reception testing. If the signal is
in acceptable signal quality in the
first 30 seconds, leave the clock
there. Otherwise, place it in other
positions and press it again.
RESET key:
-
In case of mal-function, use a pin
to press the RESET key to re-
start the clock.
FOCUS key:
-
Adjust the clearness of the
projector.
PRODUCT DESCRIPTIONS
1. SNOOZE/LIGHT key
2. REVERSE key
3. LCD display
4. PROJECTOR
5. MODE key
6. SET key
7. ADJUST key
8. RECEIVE key
9. RESET key
10. DC adaptor
11. FOCUS key
12.Battery compartment
DISPLAY SYMBOLS
Normal time mode
1. Time
2. Month
3. Date
4. Day of the week
5. Temperature
6. Signal strength indicator
7. Daylight savings time
8. Low battery indicator
Alarm Time Mode
1. Alarm time
2. Alarm mode
3. Alarm icon
4. Snooze icon
ABOUT THE DAYLIGHT SAVING
TIME (DST)
The clock has been programmed to
automatically switch when daylight
saving time is in effect. Your clock
will show “DST” during the summer.
SIGNAL STRENGTH INDICATOR
The signal indicator displays signal
strength in 4 levels. Wave segment
flashing means time signals are
being received. The signal quality
could be classified into four types:
If the RC clock receives signal
successfully, a Sync-time symbol
“
”appears on LCD. The unit is
already synchronized with the time
signal transmitter. Otherwise the
antenna segment will disappear from
the LCD display.
Note:
You may use the RECEIVE button to
receive the time signal manually. The
receive mode will stop automatically
after 6-12minutes. Test mode
consumes more battery power that
may reduce battery lifetime.
