17 |
P a g e
•
The barcodes are also important identifiers for the La Crosse View™ app if you choose to
connect.
HOW DO I DELETE SENSOR ID NUMBERS?
In the rare event you need to replace your sensor, you will first need to delete the old sensor ID
from your station.
1.
Remove batteries from your old sensor.
2.
Press and release the SENSOR button to view your sensor ID number.
3.
While viewing your sensor ID, hold the (-) button for 5 seconds to delete your old sensor ID.
Dashes will show for the ID number.
4.
Your station will automatically begin searching for the new sensor.
5.
Install batteries in your new sensor and allow up to three minutes for your new sensor
readings and ID to appear on your station.
FACTORY RESET: HOW DO I FACTORY RESET MY STATION?
•
A factory reset will delete all sensor ID numbers and if connected, remove all Wi-Fi
connections.
•
Basically this is a great way to return your station to “out of the box” condition.
•
This is more effective than removing all power for clearing out the station.
•
All history records will be removed, so write down anything you want to keep.
To factory reset your station:
1.
Hold the RAIN and LIGHT buttons together for 5 seconds.
2.
When your station resets it will look for all sensors. Allow at least ten minutes to reacquire
the sensors.
Note: If operating connected, you will need to reconnect to Wi-Fi from the app.
DASHES TEMP/HUMIDITY: WHY DOES MY THERMO-HYGRO SENSOR SHOW
DASHES ON THE STATION?
Dashes indicate the connection is lost between your station and the outdoor sensor.
•
My first thought is always to check that my
are good. If it has been working and
now is not, low batteries are the most common connection problem.
•
distance, resistance and interference
. If everything was working previously
at the same location, this is likely not the issue. However sometimes there is new growth on
trees or bushes that cause another barrier. Radio Frequency (RF) signal does not travel well
through foliage due to the moisture content.
•
Occasionally adding a new wireless electronic device to the home will cross the signal path
for the sensor. If this occurs try moving your station a few feet or turning the station 90
degrees for a better angle to receive the sensor signal.
