La Crosse Technology 513-1417V2, Faqs

Page: 9 / 12

La Crosse Technology, Ltd. www.lacrossetechnology.com/support Page 9

First Quarter and Last Quarter moons occur when the moon is at a 90 degree
angle to the earth and sun. We see half of the moon illuminated and the other
half in shadow.
Dashes, HH.H, LL.L or stuck Indoor Temperature
Explanation: These symbols are error messages indication the indoor sensor is
outside of its readable range. For indoor readings, this is generally a power related
issue.

Batteries may be overpowered or underpowered. Remove batteries from the
atomic clock.

Press any button 20 times. Leave the atomic clock unpowered for 1-2 hours.

Install fresh Alkaline batteries with correct polarity.

If the indoor temperature still shows dashes, HH.H or LL.L, the atomic clock may
need replacement.
Inaccurate Indoor Temperature Reading
Explanation: When the indoor temperature is inaccurate, it is often due to the
location of the display or overpowered/under powered batteries. You can test the
accuracy at your home.
Side-by-side test: Bring the remote sensor in the house and place it next to the
atomic clock for 2 hours.

Compare indoor and remote temperature. The temperature should be within 4
degrees to be within tolerance.

Look for heat sources such as sunlight, door or window frames or reflected heat
or cold near the atomic clock.
Set Time Alarm
Hold the ALARM button for 5 seconds to enter the alarm setting mode.
1. The alarm hour digit will flash in the time display.
2. Press and press the + or - buttons to select the hour.
3. Press and release the ALARM button to set the minutes.
4. The minute digits will flash.
5. Press and press the + or - buttons to adjust the minutes.
6. Confirm with the ALARM button and exit.
Activate/Deactivate time alarm

Press and release the ALARM button once to show alarm time.

Press and release the ALARM button to activate/deactivate the Alarm.

The bell icon will disappear when the alarm is no longer active.
Snooze Alarm

When the alarm sounds, press the LIGHT button to trigger snooze alarm for 10
minutes. The snooze icon will flash when the snooze feature is active.