La Crosse Technology, Ltd. www.lacrossetechnology.com/support
Page 9
Dashes, HH.H, LL.L or stuck Indoor Temperature
Explanation:
These symbols are error messages indication the indoor sensor is
outside of its readable range. For indoor readings, this is generally a power related
issue.
•
may be overpowered or underpowered. Remove batteries from the
atomic clock.
•
Press any button 20 times. Leave the atomic clock unpowered for 1-2 hours.
•
Install fresh Alkaline batteries with correct polarity.
•
If the indoor temperature is still shows dashes, HH.H or LL.L, the atomic
clock may need replacement.
Inaccurate Indoor Temperature Reading
Explanation:
When the indoor temperature is inaccurate, it is often due to the
location of the display or overpowered/under powered batteries. You can test the
accuracy at you home.
Side-by-side test:
Bring the remote sensor in the house and place it next to the
atomic clock for 2 hours.
•
Compare indoor and remote temperature. The temperature should be within
4 degrees to be within tolerance.
•
Look for heat sources such as sunlight, door or window frames or reflected
heat or cold near the atomic clock.
Set Time Alarm
Hold the ALARM button for 5 seconds to enter the alarm-setting mode.
1. The alarm
hour
digit will flash in the time display.
2. Press and release the + or - buttons to select the hour.
3. Press and release the ALARM button to set the minutes.
4. The
minute
digits will flash.
5. Press and release the + or - buttons to adjust the minutes.
6. Confirm with the ALARM button and exit.
Activate/Deactivate time alarm
•
Press and release the ALARM button once to show alarm time.
•
Press and release the ALARM button to activate/deactivate the Alarm.
•
The bell icon will disappear when the alarm is no longer active.
Snooze Alarm
•
When the alarm sounds, press the LIGHT button to trigger snooze alarm for
10 minutes. The snooze icon will flash when the snooze feature is active.
•
To stop alarm for one day, press ALARM button, while in snooze mode. The
bell icon will remain solid.
•
Note
: When the alarm sounds, it continues for 2 minutes and then shuts off
completely.
