La Crosse Technology, Ltd. www.lacrossetechnology.com/support
Page 2
AC adapter
The design of this weather station is to use AC adapter (5-volt) as primary
power source.
When operating with the AC adapter cord, the
can be on continually.
When operating on AC adapter, batteries are optional and are not required in
the weather station.
will operate at high or low intensity at your discretion.
Batteries
Explanation: Many problems are resolved with fresh batteries of the appropriate
voltage. Many items sent in under warranty, work when tested with fresh batteries.
Batteries manufactured this year will have an expiration date 10 years (or more) in
the future. Battery technology has improved and batteries will maintain voltage
longer in storage. However, the environment the batteries reside in for the 10 years
can deplete the power.
Use Alkaline or Lithium batteries in the outdoor sensor.
A minimum voltage of 1.48V for each battery is necessary for proper
performance.
Use batteries dated at least six years in advance of the current year. Batteries
dated earlier than six years from now may still work, but may be unstable in
performance.
Good name brand batteries make less noise, which reduces the chance of RF
(radio frequency) interference from the battery compartment.
Weather Station Factory Restart
Explanation: The factory restart returns the weather station and outdoor sensor to
an “out-of-the-box” default state and often resolves an issue.
Factory Restart:
1.
Remove all power (batteries and AC) from outdoor sensor and weather station.
2.
Press one of the buttons on the weather station at least 20 times to clear all
memory.
3.
Verify that the weather station is blank before proceeding (there may be lines
painted on the screen that will show when there is no power).
4.
Leave both units without power for 15 minutes (very important).
5.
Insert the AC adapter cord into the wall outlet then into the weather station.
6.
Insert fresh batteries into the outdoor sensor.
7.
Press the TX button on the outdoor sensor to transmit RF signal.
8.
Keep the outdoor sensor 5-10 feet from the weather station.
9.
When RF connection is established, the temperature will appear on the station.
Allow the outdoor sensor and weather station to sit together for 15 minutes to
establish a strong connection.
10.Do not press buttons for 15 minutes.
For optimum 433MHz transmission, place the outdoor sensor no more than 196
feet (60 meters, open air) from the weather station.
