Model: 308-1425CA https://www.lacrossetechnology.com/308-1425ca Page | 4
Detailed Setup: Weather Station and Remote Sensor
STEP 1:
•
Insert the 5-volt A/C power adapter into the designated area on the
back of the weather station.
•
Plug the A/C power adapter into a wall outlet for continuous backlight
(ON/OFF), and dimmer feature.
STEP 2:
(optional battery operation)
Slide tab to down and pull out to remove the battery cover.
Insert three new AAA Alkaline batteries into the back of the weather
station. Observe the correct polarity (see marking inside the battery
compartment).
The weather station will light up and show indoor temperature, humidity and time.
(Backlight will illuminate for 10 seconds when using only battery power with a
press/release of the SNOOZE/LIGHT button)
STEP 3:
•
Ensure that the transmitter is within 10 feet of the weather station.
•
Remove battery cover from transmitter. Slide the battery cover down and lift off the
front.
•
Insert two new AA batteries into the TX141TH-Bv3 transmitter. Observe the correct
polarity.
•
Within three minutes, the Weather station will show readings in the remote temperature
area on the LCD.
Note:
Use Alkaline batteries (or Lithium for temperatures below -29°C/-20°F).
Button Functions
▼ (
Down) Button
Setting-
•
Press to decrease values during setting.
•
Hold 2 seconds to quickly adjust values.
Default Time Display-
•
Press to display minimum temperature/humidity.
•
Hold 2 seconds to clear minimum temperature/humidity memory.
Temperature Alert-
•
Press to disarm alerts
TIMESET Button
Default Time Display-
•
Press to start or stop a WWVB time signal search
•
Hold for 3 seconds to set time/calendar, etc.
The weather station
has 5 buttons up the
right side and 2
buttons on the front.
