L-3 Communications, Narda Safety Test Solutions
Page 4
Narda 8950/10 Stray Voltage Detector
Unpacking the system
The 8950/10 system is sent in 3 different containers. Container 1 includes
the main mount and sensor enclosure. Container 2 includes the Panasonic
Toughbook computer and the third container includes the sensor,
charger, adapter and cables.
It is recommended that you first install the vehicle mount assembly. Tools
required are a 3/4” and 9/16” socket and large Phillips screwdriver.
Assembling the system
Step 1
Installation of Hitch Support assembly. Place
entire vehicle mount assembly behind the
vehicle, on the ground. Remove hardware
from the side of the hitch support assembly
and slide the assembly in to the two inch
receptacle. Install the hardware only finger
tight at this time. The hitch support can be
mounted in either an up or down
configuration, but in most mid and full sized trucks it can be used
facing upwards.
Step 2
Installation of upper bed mounts.
Carefully swing arms out and around the
end of the truck and position these
above the truck’s tie down socket. The
upper bed mounts are supplied with a
spring loaded toggle bolt that is
designed to hold itself to the truck that
has had its plastic rail covers removed (if required) to access the tie down
sockets. Note that the upper bed mounts present a side that is sloped towards
the middle of the vehicle. Initial adjustment should be snug but still allow the
upper bed mounts to move while the horizontal arms are attached to them.
IPR2014-00839
Exhibit 2178
Page 4 of 15