WORLD PROVIDER - INNOVATIVE HEATING SOLUTIONS
411 Mason Street, Onalaska, WI 54650 • 800-345-7200 • 608-783-5691 • 608-783-6115 (fax) • www.lbwhite.com
Guardian
Flame Sensor Kit
View these instructions online at www.lbwhite.com
Kit Contents:
Tools required:
- 5/16 nut driver or standard screwdriver
- Wire cutting/stripper/crimping tool
- Heat gun, small hand-held torch, or butane lighter
DESCRIPTION
QTY.
Flame Sensor
1
Heat Shrink Tube
1
1/4” Male Quick Connect Terminal
1
Mounting Hardware
1
Installation Instructions
1
INSTALLATION INSTRUCTIONS
Qualifications for installation of the kit:
• You must be able to read and understand these instructions.
• You must be properly trained and have suffi cient experience to install the kits.
• You must be able to test the heater for proper operation and place the heater in a
continuing safe and normal operating condition.
Discussion:
• Use this kit to maintain corrosion resistance of the electrical connection when replacing the fl ame sensor.
• Depending on the service kit, not all the parts may be use.
Initial Preparation:
• Disconnect the heater from its electrical supply.
• Close all fuel supply valves to the heater.
• Open the heater’s access door at the gas inlet end of the heater.
