Rigging procedures
Array removal
About this task
All along the procedure:
Strictly follow the sequence of the successive steps.
Systematically verify that each BLP is fully inserted.
For clarity purposes the loudspeaker cable removal procedure will not be described.
The loudspeaker cables will not be represented on the gures.
Procedure
1.
Remove the ratchet strap from the array.
2.
Place an empty Kara ight-case at the rigging location and remove the lid.
3.
Separate the top Kara (KARA#3 for example) from the Kara below (KARA#2 for example) as follows: remove the 4
top link R-BLP from KARA#2 and re-insert them into the top storage holes.
4.
Lift up and turn KARA#3 arms upwards. Put KARA#3 into the ight-case tray.
Pay attention to the tray position: both wedges must slope upwards from front to rear (refer to
(p.25)).
FRO
NT
Kara owner's manual (EN) version 1.0
97
