L-Acoustics LA-RAK, Owner'S Manual

Page: 93 / 201

Rigging procedures
6.
Remove both front R-BLP from the M-BUMP. If the M-BUMP has been congured without KARA-ANGARMEX, also
remove both rear R-BLP.
7. Place a full Kara ight-case at the stacking location and remove the lid. In the following, the enclosures will be
designated as KARA#1 to KARA#3 from top to bottom.
8.
Set KARA#1 in stacking conguration as follows (repeat for each side):
a) Remove the front top R-BLP from its storage hole, rotate the front arm up, slide it down, and secure by reinserting
the R-BLP into the top yellow link hole.
b) Remove the rear top R-BLP from its storage hole, slide the angle arm so as to align the cursor with the
chosen angle value, and secure by re-inserting the R-BLP into the corresponding angle hole (0°/2°/4° or
1°/3°/5°/7.5°/10°). Refer to Array site angle setting (p.196) for equivalence between the chosen angle value
and the array site angle.
c) Remove the front and rear bottom link R-BLP and re-insert them into the bottom storage holes.
Kara owner's manual (EN) version 1.0 93