Rigging procedures
10.
Open the four KARA#1 arms as follows (repeat on both sides of the enclosure):
a) Remove the front top R-BLP from its
storage
hole, rotate the front arm up, slide it down, and lock it in place by
re-inserting the R-BLP into its
link
hole.
A
link
hole is indicated by a yellow circle.
The front top
storage
and
link
holes are the same.
b) Remove the rear top R-BLP from its
storage
hole, slide the angle arm so as to align the cursor with the chosen
angle label, and lock it in place by re-inserting the R-BLP into the corresponding angle hole (0°/2°/4° or
1°/3°/5°/7.5°/10°).
Refer to
(p.198) to obtain the angle value corresponding to the chosen array
site angle.
a.
b.
Kara owner's manual (EN) version 1.0
125