Rigging procedures
5.
Set angle 0° on KARA#3 as follows (repeat on both sides of the enclosure):
a) Remove the rear top R-BLP from its angle hole.
b) Slide the angle arm so as to align the cursor with angle label 0°.
c) Lock the arm in place by re-inserting the R-BLP into angle hole 0°/2°/4°.
6.
Remove KARA#2 from KARA#1 by applying step
(p.109).
7.
Attach KARA#2 to KARA#3 as follows:
a) Lift up and turn KARA#2 arms pointing up.
b) Align the front and rear link points between KARA#2 and KARA#3.
c) Secure the link points together by removing the four KARA#2 bottom R-BLP from their
storage
holes and
reinserting them into their
link
holes.
8.
Set angles 0° on KARA#2 by applying step
(p.110).
9.
If the last Kara to be placed in the ight-case is not attached to the KARA-MINIBU (KARA#4), apply steps
(p.109),
(p.110),
(p.112), and
(p.112) for KARA#4 and then apply the procedure a new time from
step
(p.109) for array KARA#1-3.
If the last Kara to be placed in the ight-case is attached to the KARA-MINIBU (KARA#1), attach the KARA#1/platform
assembly to KARA#2 by applying step
(p.110).
110
Kara owner's manual (EN) version 1.0
