Rigging procedures
Array removal
About this task
All along the procedure:
Strictly follow the sequence of the successive steps.
Systematically verify that each BLP is fully inserted.
For clarity purposes the loudspeaker cable removal procedure will not be described.
The loudspeaker cables will not be represented on the gures.
Procedure
1.
Detach the ratchet strap or other equivalent material from the stacked array.
2.
Bring an empty Kara ight-case to the rigging location and remove the lid.
3.
Remove the top Kara (KARA#3 for example) from the Kara below (KARA#2 for example) by removing the four
KARA#2 top R-BLP from their
link
holes and re-inserting them into their
storage
holes.
4.
Lift up and turn KARA#3 arms pointing up. Put KARA#3 into the ight-case tray.
Pay attention to the tray position: both wedges must slope upwards from front to rear (refer to
(p.25)).
FRO
NT
Kara owner's manual (EN) version 1.0
109